Loading ...
Loading ...
Loading ...
14,IMPORTANT:TheSPREADERmustalwaysbe
PARALLELtothesawbladeandintheMIDDLEofthe
cut(KERF)madebythesawblade.
NOTE:Thespreaderisthinnerthanthewidthofthe
KERFbyapproximatelysixthicknessesofpaper.
SPACEEQUALTOAPPROX.
3THICKNESSESOF PAPER KERF WOOD
SPREADER
SPACE EQUAL TO APPROX. LOOKING DOWN ON SAW
3 THICKNESSES OF PAPER
BLADE
/
15. Make two folds in a small piece (6 x 6 in.) of ordinary
NEWSPAPER making three thicknesses,
The folded paper will be used as a "'spacing gauge".
16. Place RIP FENCE on table ...
CAREFULLY move it against blade so that it is parallel
to the blade, and just TOUCHES tips of saw teeth . .
tighten RIP FENCE LOCK KNOB HANDLE.
17. Insert foldea paper between SPREADER and
FENCE..,hold spreader flat against fence ..tighten
screws using 7/16 in wrench Now tighten Hex Hd.
Screws in Support.
18. To remove BLADE GUARD AND SPREADER, loosen
THUMBSCREW... DO NOT LOOSEN OTHER
SC REWS.
7/16 N. WRENCH
\
FOLDED PAPER
MOUNTING THE MOTOR
NOTE: Motor i_ included with Model 113.296032 and
113.298240.
CHECK MOTOR ROTATION
1. The motor must rotate CLOCKWISE when viewed from
the 5/8 in. shaft.
2. MAKE 'SURE "KEY" IS REMOVED FROM SHAFT.
3, Place the motor on your workbench or 3n the floor.
4. Plug the cord into a prcperly grounded outlet ISee
"Motor Specifications and Electrical Requirements"
Section) Notice the rotation of the shaft, If it is not
turning CLOCKWISE, REMOVE the plug from the
outlet, and change the rotation of the motor according
to the instructions furnished with the motor,
KEY
/
5/8 IN. qON
DIA. SHAFT
WARNING: FOR YOUR OWN SAFETY, MAKE SURE
PLUG IS NOT CONNECTED TO POWER SOURCE
OUTLET WHEN CHANGING MOTOR ROTATION.
16
Loading ...
Loading ...
Loading ...