Loading ...
Loading ...
Loading ...
DADOING
Instructions for operating the Dado Head are contained iP
booklet furnished with the Dado Head
The Recommended Dado Head is listed under
Recommended Accessories in this manual.
Th_ arbor on the saw, is omy long enough so that the
widest cut that can be mace is 13/16" wide.
It is not necessary to install the outside loose collar before
screwing on the arbor nut. Make sure the arbor nut is tight.
ALWAYS USE DADO INSERT LISTED UNDER
RECOMMENDED ACCESSORIES.
When using .the dado head it will be necessary to remove
[he Blade Guard and Spreader. USE CAUTION. USE
FEATHERBOARDS AND PUSH STICKS AS REQUIRED.
ALWAYS REPLACE THE BLADE, GUARD AND
SPREADER WHEN YOU ARE FINISHED DADOING.
MOLDING CUTTING
Instructions for operating the Molding Head are contained
in a booklet furnished with the Molding Head.
The recommended molding head is listed under
Recommended Accessories in this manual.
Always use Molding Insert Listed Under Recommended
Accessories.
SAW TABLE DADO NSERT
/
@
When using the molding head it will be necessary to remove
the Blade Guard aria Spreader. USE CAUTION. USE
FEATHERBOARDS AND PUSH STICKS, etc. AS
REQUIRED.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER WHEF, YOU ARE FINISHED MOLDING.
USING FEATHERBOARDS
Add 8 inch high flat facing board to the fence, the full
length of the fence,
Use featherboards for all non "thru-sawing" operations
(when sawblade guard must be removed). Featherboards are
used to keep the work in contact with the fence and table
as shown, and to stop kickbacks.
Mount featherboards to fence and table as shown, so that
leading edges of featherboards will support workpiece until
cut is complete, and the workpiece has been pushed
completely past the cutter (sawblade, dado head, molding
head, etc.) with a pushstick, as n ripping.
C CLAMPS FEATHERBOARD
Before starting the operation {switch 'OFF' and cutter
below table surface):
(a) Install featherboards so they exert oressure on the
workpiece; be oositive they are secure, and
(b) Make sure by trial that the featherboards will stop a
kickback if one should occur.
Featherboards are not employed during non thru-sawing
operations when using the miter gage.
Replace the sawblade guard as soon as the non thru-sawing
operation is complete.
"c" CLAMPS
WORK SUPPORT
"C CLAMPS
3O
Loading ...
Loading ...
Loading ...