Loading ...
Loading ...
Loading ...
2524
BEFORE USING THE APPLIANCE
Preparing The Dishwasher For First Use
• Make sure the electricity and supply water specifications match the values
indicated in the installation instructions for the dishwasher.
• Open the door of the dishwasher.
• Remove all packaging material inside the dishwasher.
• Set the water softener level.
• Set the rinse aid dosage.
• Fill the salt container.
• Fill the rinse aid compartment.
• Place the dishes in accordance with the instructions in this manual.
• Put adequate amount of detergent into the detergent dispenser.
• Make sure that the upper and lower impellers rotate freely.
• Select program according to amount of dirt.
• Close the door of the dishwasher. (Push the baskets in, then lift the door upwards
and push until it clicks into position)
CAUTION: To prevent injuries, ensure that your hand is not jammed or
crushed between the door and appliance
WARNING: All functions are automatically interrupted if the door is opened
while the appliance is running.
CAUTION: There may be a escape of hot steam when you open the door of
the dishwasher. Be careful of getting injured.
OPERATION
MAINTENANCE INFORMATION
1. When the dishwasher isn’t in operation:
• Disconnect the plug and close the tap.
• Leave the door slightly open to prevent odor formation.
2. Select the dry option to remove water droplets.
3. Place dishes in the dishwasher properly to achieve the best energy consumption,
washing and drying performance. Please see the program and consumption
table for more information.
4. Rinse dirty dishes before placing them in the dishwasher.
5. Only use the Rinse program when necessary.
6. Do not place the dishwasher near a refrigerator because it will reach high
temperatures.
7. If the dishwasher is located in an area that is at risk of freezing, close the tap,
disconnect the inlet hose from the tap and drain the water inside the hose and the
dishwasher completely. Dispense outside of the metropolitan region.
SETTING THE WATER SOFTENER
• Dishwasher needs soft water for good cleaning results. Hard water results in a
build-up of calcium deposits on dishware and in the dishwasher. The dishwasher
has a special water softening system to remove the hardness of the tap water.
Setting this system correctly will increase the washing effectiveness.
• Water supplies with a hardness level higher than 9° F needs to be softened.
• If the hardness level of the water that you use is above 9° F or if you are using
well water, than it is recommended to use filter and water purification devices.
• The dishwasher is programmed at the factory setting level 1 (inactive) of water
hardness. If this setting corresponds to the hardness of your water, no actions
need to be taken. The dishwasher must be programmed for the water hardness in
your area.
• To find out the hardness level of water in your area, contact your local Water
Board or determine water hardness level by the help of test strip provided.
WARNING: If you move to a different location, the level of water
hardness will possibly be different. It is essential to setting again the
water hardness in order to obtain optimum washing efficiency.
OPERATION
First Use
Setting the Water Softener
CAUTION
CAUTION
WARNING
WARNING
Loading ...
Loading ...
Loading ...