Loading ...
Loading ...
Loading ...
21
ATTACH THE M OUNTING
PLATE TO THE WALL
B3.
•
Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it under neath t h e t op cabi n et .
• Drill the holes, following the instructions on the
TOPCABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Wal l
Mounting
Plate
Spacing for Toggl es More
Than Wall Thickness
Toggl e
Bol t
Toggl e Wi ngs
To use toggle bolts:
Bolt End
Installation Instructions
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
Remove the toggle wings f r om t h e bol t s.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3
⁄4″ (19 mm) onto each bolt.
1
2
Pl ace t he m oun t i n g pl at e agai n st t he wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOT E: Before tightening toggle bolts and wood
scr ew, make sur e the bottom of t h e m ounti n g pl ate
touch the bottom of the cabinet when pushed flush
agai n st t h e wall and t hat t he p lat e i s pr op er l y
center ed under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between t h e back of the moun t i ng plate and the wall .
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
3
4
2
1
Remove and save screw that holds blower motor
to microwave.
ADAPTING M ICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
B5.
End B
End A
will extend far enough to allow you to adjust
the bl ower uni t .
Back of
Microwave
Blower Motor
Blower Motor
Screw
For w ar d
Openings Facing
Carefully pull out the blower unit. The wires
Before: Fan Blade
USE TOP CABINET TEM PLATE
FOR PREPARATION OF TOP
CABINET
B4.
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Back of
Microwave
Roll the blower unit 90°
Back of
Microwave
3
Before Rot at i on After Rotation
EN-17
INSTALLATION
Loading ...
Loading ...
Loading ...