Loading ...
Loading ...
Loading ...
16
USE TOP CABINET TEM PLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
A2.
•
Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it under neath t he top cabi n et.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Inst allat ion Inst ruct ions
A3.
Remove the screw that hol ds th e blower pl ate
to th e mi cr owave. Remove and save th e screw
holding the blower motor to the microwave.
Bl ower Pl at e
Bl ower Motor
Screw
Back of
Microwave
2
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the bl ower uni t .
1
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
Roll the blower unit 90° so that fan blade
mi cr owave.
3
Back of
Microwave
Bef ore Rot at i on After Rotation
Back of
Microwave
openings are facing out the top of the
Back of
Microwave
AFTER: Fan Blade
Place the blower unit back into the opening.
Openings Facing Top
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
4
with the top of the unit facing up.
Place the microwave in its upright position,
EN-13
End B
End A
Back of
Microwave
INSTALLATION
Loading ...
Loading ...
Loading ...