Loading ...
Loading ...
Loading ...
25
!6 DUAL INSTALLATION
Positioning and aligning the first appliance inside the cabinetry
1 Coil the water hose flat behind the appliance. (Refer to ‘Connect to water and power supply’).
2 Before rolling the appliance, insert a barbed plug into a large hole on the cabinetry side of
the first appliance to protect the inside of the cabinetry from being damaged by screws on
the side of the appliance (A).
3 Roll the first appliance (preferably, Freezer) inside the cabinetry (B).
– Ensure that the water hose is not run over to prevent damage and possible water leak.
4 Continue rolling the appliance into the cabinetry until the anti-tip bracket overlaps
[minimum 7 1/8” (180mm)] the back top surface of the appliance. (Refer to ‘Attach the anti-
tip bracket’).
5 Check the clearance between the floor and the feet. Ensure the rollers of the appliance can
roll freely on the floor.
6 Align the top cap of the first appliance flush with the front of the spacer (C).
7 Mark the step (D) of each alignment gauge based on the thickness of the door panel to be
installed to the door.
8 Align the marked steps of the gauges flush with the edges of the cabinetry side walls.
– Place a ruler on the steps of the alignment gauges to check if they are in line (E)
relative to the thickness of the door panel.
9 Check if the gaps between appliance and cabinetry side wall are even.
Required components/tools:
Ruler
1x Barbed plug
IMPORTANT!
Make sure that all feet engage the floor and evenly support the product. Tighten the
adjustment screw with screwdriver (do not use powered driver).
E
D
C
Note: The appliance can be rolled first into the left side or right side
of the cabinetry depending on your preference.
B
A
Loading ...
Loading ...
Loading ...