Loading ...
Loading ...
Loading ...
15
POWER
When power is connected to the Incline stepper the console will automatically power up. These models are
connected directly to 120-volt,15-amp and there is a power switch located where the line cord plugs into the
unit on the left side near the middle.
When it is rst powered on, the console will perform an internal self-test. During this time all the lights will turn
on, the Message Window display will show a software version (i.e.: VER 1.0), and the VERTICAL Window will
display an altimeter reading. The Time Window shows how many total hours the Incline stepper has been used.
The altimeter and time will remain displayed for only a few seconds then the console will go to the start up
display. The dot matrix display will be scrolling through the different proles of the programs and the Message
Center will be scrolling the start up message. You may now begin to use the console.
Dot Matrix Center Display
Twenty columns of boxes (10 high) indicate each segment of a workout. The boxes only show an
approximate level (resistance) of effort. They do not necessarily indicate a specic value - only an
approximate percent to compare levels of intensity. In Manual Operation the resistance dot matrix
window will build a prole “picture” as values are changed during a workout.
The Lap track will move in a counterclockwise direction.
Loading ...
Loading ...
Loading ...