Loading ...
Loading ...
Loading ...
• Placea supportthe same heightas the topofthe
sawtable behindthe saw for the cut work.
• Positionthe dpfencethe correct distancefrom the
bladeforthe cut.
• For smallpieces ofwood, use a pushstickto move
thewood intoand pastthe blade,
• Make surethe wood isnottouchingthe blade.
Insertthe key and liftthe switchto the ON position.
Letthe bladebuildupto full speed beforefeeding
the workpiecointothe blade.
• When the work iscompleted,pressthe switch off
and removethe key.
RiPCUT
BLADE
SCALE
BF
FENCE
Fig. 49
MAKING A MITER CUT
See Figure 50.
Make a test cut on scrap wood, Fromthe frontofthe
saw, pushthe woodto the bladewith the miter gage.
j_, WARNING: Make sure the bladeguard is
lowered over blade and isworkingpropedyto
preventpossibleinjury.
• Check thatthe blade isat the correct height for the
workpiece,To change the height,turnthe height
handwheel.
• To setthe wood angle, loosenthe miter gage knob,
setthe angle withthe indicatoron the mitergage,
then retightenmitergage knob.
• Place a supportthe same height as thetop ofthe
sawtable behindthe saw for the cutwork.
• Make sure thewood isnottouchingthe blade
beforeturningonthe saw. Insertthe key and lift
the switch to the ON position. Letthe bladebuild
uptofullspeed beforemovingthe mitergage to
feed theworkplacointothe blade.
• Holdthe workfirmlyagainstthe mitergage and
pushthe mitergage to feed the work intothe blade.
• When thework iscompleted,pressthe switch off
and remove the key,
MITERCUT
BLADE ____________ MITERGAGE
STRAIGHT ANGLED
BEVEL
HANDWHEEL
HANDWHEEL
Fig, 50
MAKING A BEVEL CROSS CUT
See Figures 51 and 52.
Try out thiscut ona pieceof scrapwoodbefore
cuttingyourworkpiece,
,_ WARNING: Make surethe blade guard is
lowered over blade and is workingpmpedyto
preventpossible injury,
!/1EWEDFROMTHE FRONT,BELOWTHE TABLESAW
BEVEL
HEIGHT LOCKHANDLE
HANDWHEEL
LOOSEN
TOTIGHTEN Fig. 51
CRRFll3MR N"TABLE SAW 315.228390 38
Loading ...
Loading ...
Loading ...