Loading ...
Loading ...
Loading ...
CHECKING SQUARENESS OF EXTENSION
TABLES TO SAW TABLE
See Figure34.
The extensiontables shouldbe checked for
squamess to the saw table for smoothoperationof
the ripfence and rails.
Place a square on the saw table, withthe shortend
up and check.The longend of the squareshould
extend across one of the extension tables. If the
extension table is not square with the saw table.
proceed as follows:
• Loosenthe two hex nuts (one for each rail)
securingthe front and rear railsto the extension
table. Do not loosen hex nuts secudng railsto
saw table,
• Raise or lowerextension table until itis square
with the saw table.
• "13ghtenhex nuts securely.
• Check extension table on oppositeside of blade.
Repeat the above procedureif necessary.
SAWTABLE
o o
I
EXTENSION
TABLE
EXTENSION
TABLE
F-1
SAWTABLE [ _'_- SQUARE
II ,-,., I
EXTENSION I_DI,_ON
TABLE TABLE
Fig.34
29 CRBFT._'MBrI'ABLE,_W $18.2211_0
Loading ...
Loading ...
Loading ...