Loading ...
Loading ...
Loading ...
• Check the 45° setting.Tilt the bladewith the bevel
handwheelas far as it willgo to the left. Placethe
squareagainstthe blade(be surethe squareisnot
againstone of the saw teeth). If the blade isnot at
45°, unscrewthe 45 ° stop screw (dghtof blade),
turnthe hendwheel untilthe blade iscorrect,and
tightenthe screw. Recheck and repeat ifneces-
seW.
• Check that the scale indicatorisat 45°,
• If not,loosenthe scaleindicatorwith a screwdriver,
adjustitwithinthe slot,and retightenthe screw.
• Loosenknoband pull outon stop pinto rotate
miter gage base pest stop screws.
• Loosenthe lock nut ofthe 0° stop screwat the
stop pinwith a 8 mm wrench.
• Place a 90" square againstthe miter gage rodand
the mitergage base.
• If the rodisnot square, loosenthe knob, adjustthe
rod, and tightenthe knob.
• Adjustthe 0° stop screwuntil it rests againstthe
stop pin.
• Adjustthe plusand minus45° stop screws usinga
45° tdangle and the stepsabove,
MITER
GAGEROD MITER
GAGEBASE
KNOB
SCALE
INDICATOR
Fig, 42
ADJUSTING THE MITER GAGE
See Figure 43.
You can setthe miter gage at 0° and plusor minus
45° withthe mitergage stop pinand adjustable stop
SCreWS,
Note: The mitergage providescloseaccuracy in
angled cuts. For very closetolerances,test
cutsare recommended.
45'
STOPSCREW
0° ADJUSTABLE
STOPSCREW
LOCKNUT
STOPPIN
Fig. 43
33 CRflFTSMRN"TABLESAW316.228390
Loading ...
Loading ...
Loading ...