Loading ...
Loading ...
Loading ...
INSTALLING THE FRONT RAIL
See Figures 15and 16.
• Get the front rail pieces,the switchassembly,and
thefollowing hardware:
6 square head bolts(5/16-18 x 1 in.)
6 flat washers (5/16 in.)
6 hex nuts(5/16-18)
2 screws(1/4-20 x 3/8 in.) (locatedon switch plate)
2 squarenuts (1/4-20) (located on switch plate)
Front railconnector
Rightand leftend caps for front rail
2 screws(#8-32 x 112in.)
• Set aside end capsand screwsuntilyou have
alignedthe ripfence and front rail.
• Insertthe s_ squarehead boltsintothetableand
extensions,sothe boltheadsextend outward112in.
• Looselyattach a washer and a hex nutto each
bolt.
• The backof the rail hastwo slots.Slide the upper
slot over the bolts. (Bottomslot isfor switch.)
• Alignthe dght rail from left to dght- Match the
7-1/8 in. mark on the right scale to the right
edge of the table saw base (main table). See
Figure 16.
• Snug rightrailagainsttable. Finger-tighteneach
nuton the table and extensions.
• Locate the switchassembly. The two screws are
installedthroughthe back of the switch platewith
the squarenutsextendingout towardthe front.
Note: The square nuts am looseon the switch plate.
• Slidethe square nutsintothe lowerslotofthe rail.
• Slide the switchassembly to a convenientposition,
leavingample clearancefor the hendwheel.
Tightensecurelywith a screwdriver.Do nottighten
the rail bolts.
• Attachthe and caps and screwswitha phillips
screwddver.
WARNING: Place the switchout ofthe
immediatework area to avoid accidentally
turningit off dudngoperation.
SAWTABLE TABLE
EXTENSION
SQUARE
HEADBOLTS
TABLE
EXTENSION
FRONT
CONNECTOR
FRONTRAIL
SCALE
RAILSLOT
FRONTRAIL
HEXNUT
FLAT
WASHER
Fig.15
ENDCAP
SCREW
TABLE
EXTEI_ON
SWITCHSLOT
RIGHTSCALE
ERRFTSMRN"i'ABLESAW315.22.8390
FRONTRAIL
WITHKEY
22
Fig. 16
Loading ...
Loading ...
Loading ...