Loading ...
Loading ...
Loading ...
MAKING A CROSS CUT
See Figures47 and 48.
It is recommendedthat you make test cuts on scrap
wood. Stand at the front of the saw and pushthe
wood to the bladewith the miter gage.
_lb WARNING: Make sure the blade guard is
loweredover blade and isworkingproperlyto
preventpossibleinjury.
• Set the bladetothe dghtdepthfor thewod<pleceby
tumingthe height handwheel.
• Set the mitergage to 0°. Make sum mitergage
knob is securelytightened.
• Place a supportthe same heightas the topof the
sawtable behindthe saw for thecutwork.
• The mitergage may be used in either ofthetwo
groovesinthetable. When usingleftgroove,hold
workpiecefirmlyagainstthe mitergage basewith
your left:handand gdpthe knobwithyourright
hand,When usingthe rightgroove, holdworkpiece
firmlyagainstthe miter gage basewithyour right
handand gripthe knobwithyour lefthand. See
F/gum 47.
• Check thatthe wood isnottouchingthe blade.
Insertthe key and liftthe switchto the ON position.
• Letthe blade buildupto full speed beforefeeding
theworkpieceintothe bladewiththe miter gage.
CROSScur
PLACELEFTHAND ON
WORKPIECEAND
MITER GAGEHERE
WHENMITERGAGEIS
ON LEFT SiDEOF BLADE
PLACERIGHTHAND ON
MITERGAGEIOiOR HERE
Fig. 47
SWITCHOFF
Fig. 48
• Hold thework firmlyagainstthe miter gage and
pushthe mitergageto feed the workintothe blade.
• When the work iscompleted,press the switch off
and removethe key,
MAKING A RIP CUT
See Figure49.
Maldnga test cuton scrapwood is highlyrecom-
mended. Fromthefrontofthe saw, positionthe wood
against the dp fence and pushit to the bladewitha
pushstick, Be sumthe end ofthe wood is square.
_lb WARNING: Never standdirectly inthe lineof
cut, Stand to the side to reducedskof injury.
_1_ WARNING: Never pusha small piece ofwood
Into the bladewithyour hand.
,d_ WARNING: Make surethe blade guard is
loweredover bladeand isworkingproperlyto
preventpossible injury,
• Removethe mitergage andattachthe dpfence
overthe roils.
37 CRRFlr'SNIIN"TABLESAW31S.228390
Loading ...
Loading ...
Loading ...