Loading ...
Loading ...
Loading ...
Note: The right side of saw is on your dghtwhen
facingthe saw, as ifyou were in normal
operating position,
INSTALLING THE REAR RAIL
See Figures 12- 14.
_k WARNING: Frontand rear railsmustbe
installedand carefully alignedto reducethe risk
of kickback, Kickbackcan resultin serious injury.
• Fromthe carton, removethe mar railpieces and
the followinghardware:
6 squarehead bolts(5/16-18 x I in,)
6 fiatwashers(5/16 in,)
6 hex nuts (5/16-18)
Rear railconnector
Rightand leftend caps for rear rail
2 screws (#8-32 x 112in.)
Note: Remaininghardware from this hardware beg is
usedfor installingthe frontrailand end caps.
• At the back ofthe table, putthe squarehead bolts
inthe holesinthe edge ofthe saw table and the
outerholesin each extensiontable sothe bolt
heads extend outward112in.
• Under thetable, looselyattachwashers and hex
nutsontobolts.Slide the sloton therear railover
the bolts.Adjusteach bolt tofit the railcloselyto
thetable.
• Positionrightrail (longestpiece) sothat righthand
edge extends 2-1/2 inches beyondtable extension.
• Push rightrailagainsttable and tighteneach nut
with a 12 mm wrench. If railjams and does not
slide easily over bolts, re-aligntable extensions.
• Put the end caps on rail ends. Insertthe screws
and tighten witha phillipshead screwdriver.
TABLE
SLOT EXTENSION
REARRAIL
SQUARE
HEADBOLTS
REAR RAIL
CONNECTOR
WASHER
TABLE
REARRAIL
Fig. 13
ENDCAP
SQUARE HE)(NUT
HEADBOLTS FLAT
WASHER Fig, 12
21
SCREW
REAROFSAW Fig. 14
CRRFTSMRN'I"ABLESAW31_2283S0
Loading ...
Loading ...
Loading ...