Loading ...
Loading ...
Loading ...
CHECK HEELING (PARALLELING) OF THE
SAWBLADE TO THE MITER GAGE GROOVE
See Figures29- 30.
DO NOT loosen any screws until you have
checked with a square and rode sure adjust-
ments are neceeaa_y. Once the screws are loos-
ened, these items must be reset.
Jl_ WARNING: Make surethe switchis off, the
switch key is removed, and your saw is un-
plugged. Failureto do so couldresult in acciden-
tal starting,resulting in serious personalinjury.
A WARNING: The sawblade mustbe parallelto
the miter gage groove sothe wooddoes not
bind,resultingin kickback.You could be hit or
cut.
• Liftthe blade guard. Raise the bladeall the way by
turningthe heighthandwbeel.
• Mark beside one ofthe sawbladeteeth at the front
of the blade. Place a framing squarebesidethe
bladeon the mark. Be surethe framingsquare is
between theteeth and fiat againstthe blade,
Measure thedistancetothe dghtmitergage
groove,
• Turn sawbladeso the marked toothis at the back.
• Move the square to the rear and again measure the
distance to the right miter gage groove. If the
distances are the same, the blade and the miter
gage groove are parallel. No adjustments are
needed.
• If the distances measured are different, adjust
the table bracket underneath the saw. See
"Heeling (Paralleling) The Sawblade To The
Miter Gage Groove" in the Adjustments se_.-
tion,
FRAMINGSQUARE
MITERGAGEGROOVE Fig. 29
MITER GAGE GROOVE Fig. 30
27 CRRFT.IflP4AN"T/_LE SAWalS,2281_
Loading ...
Loading ...
Loading ...