Loading ...
Loading ...
Loading ...
W415-2362 / A / 10.25.19
EN
32
fi nishing
5.2 door removal / installation
5.3 burner installation
See separate instructions accompanying burner assembly (sold separately).
A. Locate the door latches: one at each the left and right
side of the door between the main door and framing
edge.
B. Place the latch key into slots of the door latch.
Pull out and forward to disengage door latches.
C. Tilt the top of the door forward until you can grip the sides
of the door. Lift up and out of the bottom door retainer.
D. To re-install the door, lift onto the bottom door retainer,
pivot the top of the door into the closed position. Hold
the door in place and re secure the latches. NOTE:
These latches make up the spring relief system
for the appliance. Ensure they open freely and
close sealed.
Door Latch
Before the glass door can be removed the safety screen must be removed, refer to “safety barrier removal /
installation” section.
Reverse these steps to re-install the door and trim with safety
screen. Ensure the safety screen is installed correctly.
IMPORTANT: Once latches are engaged,
test to make sure that the door is secure
and will not fall forward.
!
WARNING
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
!
WARNING
• Do not insert fi ngers in the gap between the door and the framing edge, there is a risk of injury due to the
spring mechanism.
Loading ...
Loading ...
Loading ...