Loading ...
Loading ...
Loading ...
www.insigniaproducts.com
17
4.8 Cu. Ft. Freestanding Gas Convection Range with Steam Cleaning
Selecting a location
Clearances and dimensions
BEFORE YOU BEGIN to install your range, refer to the following information, dimensions, and clearances. Do not locate
your range where it may be subject to strong drafts. Provide adequate clearances between your range and adjacent
combustible surfaces. These dimensions must be met for safe use of your range. The location of the electrical outlet and
gas piping may be adjusted to meet the following dimensions and clearances.
For installation in Canada, a free-standing range is not to be installed closer than 4.7 in. (12 cm) from any adjacent surface.
Minimum dimensions
CAUTION:
Your range has been designed to comply with the maximum allowable wood cabinet temperature of 194° F (90 °C). Make sure that the
wall covering, counter tops, and cabinets around the range can withstand the heat (up to 194° F (90° C)) generated by your range. If
not, discoloration, de-lamination, or melting may occur.
WARNING:
If you have overhead cabinets, use a range hood that projects horizontally a minimum of 5 in. (12.7 cm) beyond the front of the
cabinets. This helps dissipate any heat buildup in the overhead cabinets to prevent death, personal injury, or a fire hazard. Install
above the cooktop with a clearance of not less than .25 in. (.6 cm) between the hood and the underside of the combustible material or
metal cabinet. The hood must be at least as wide as your range and centered over your range. Clearance between the cooking surface
and the ventilation hood surface must never be less than 24 in. (61 cm).
Exception: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installations packed
with that appliance.
• 30 in. (76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood
or metal cabinet. Or If there is not a 30 in. (76.2 cm) minimum clearance, 24 in. (61 cm) minimum when the bottom of
the wood or metal cabinet is protected by not less than .25 in. (.64 cm) flame-retardant mill board covered with not
less than a No. 28 MSG sheet steel, .015 in. (.038 cm) stainless steel, .024 in. (.061 cm) aluminum, or .020 in. (.051 cm)
copper.
• 18 in (45.7 cm) minimum between the countertop and the adjacent cabinet bottom.
30 in. (76.2 cm)
10 in.(25.4 cm) min to
left wall
10 in.(25.4
cm) min to
right wall
36 in. (91.4 cm)
.78 in. (2 cm)
30 in. (76.2 cm) min
18 in. (45.7 cm)
24 in. (61 cm)
Lower cabinet
depth
0 in. (0 cm)
Clearance
below cooktop
and at rear and
sides of range
13 in.
(33 cm)
Max.
cabinet
depth
Loading ...
Loading ...
Loading ...