Loading ...
Loading ...
Loading ...
WARNING: A risk of range tip-over exists if the appliance
is not installed in accordance with the installation
instructions provided. The proper use of this device
minimizes the risk of TIP-OVER. In using this device the
consumer must still observe the safety precautions as
stated in the OWNER'S MANUAL and avoid using the
oven door and/or lower drawer as a step stool.
Installation instructions are provided for wood and cement
in either floor or wall. Any other type of construction may
require special installation techniques as deemed
necessary to provide adequate fastening of the ANTI-TIP
bracket to the floor or wall. The bracket may be installed to
engage the left or right rear leveling leg.
STEP 1 - Locating The Bracket (See Figure 4)
A. Mark the floor or wall where either the right or left rear
"EDGE" of the range is to be located.
B. Place the BRACKET 15/16" from the marked "EDGE"
toward center of opening and against the back wall, as
shown in figure 4.
C. Use the bracket as a template and mark the required
holes, as shown in figure 4, for the type of construction
you will be using.
D. Slide-in ranges may be secured to either floor or wail.
Drop-in range may only be secured to slat or solid
floor in cabinet.
STEP 2 - Anti-Tip Bracket Installation
A Wood Construction:
1. Floor: Locate the center of the two holes identified
in figure 4 as "HOLES FOR FLOOR". Drill a 1/8"
pilot hole in the center of each hole (a nail or awl
may be used if a drill is not available). Secure the
ANTI-TIP bracket to the floor with the two screws
provided. Proceed to Step 3.
. Wall: Locate the center of the two holes identified
in figure 4 as "HOLES FOR WALL". Drill an angled
1/8" pilot hole in the center of each hole as shown
in figure 5. (A nail or awl may be used if a drill is
not available). Secure the ANTI-TIP bracket to the
walt with the two screws provided as shown in
figure 5. Proceed to STEP 3.
B, Cement or Concrete Construction:
1. Suitable screws for concrete construction can be
obtained at the hardware store. Drill the required
size hole for the hardware obtained into the
concrete at the center of the holes identified in
figure 4 as "HOLES FOR FLOOR". Secure the
ANTI-TIP bracket to the floor. Proceed to STEP 3.
ANTI-TIP---_
BRACKET
HOLES FOR
FLOOR
WALL
FOR
i * _KED EDGE
_11 OF RANGE
5/16" FROM
_RANGE FOOT EDGE OF RANGE
FIGURE 4
Loading ...
Loading ...
Loading ...