Loading ...
Loading ...
Loading ...
With side collision warning
If at speeds between 45 mph/70 km/h and
130 mph/210 km/h the vibrating steering wheel
is ignored and the lane marking crossed, the sys‐
tem intervenes with a brief active steering inter‐
vention. The steering intervention helps return
the vehicle into the lane. The steering interven‐
tion can be noticed on the steering wheel and
can be manually overridden at any time.
Flashing of the light
A flashing of the light during vehicle unlocking
serves as system self-test.
System limits
Safety information
WARNING
The system can react not at all, too late, incor‐
rectly, or without justification due to the system
limits. There is a risk of accidents or risk of
damage to property. Follow the information re‐
garding the system limits and actively intervene
if needed.
Upper speed limit
If the vehicle speed exceeds approx.
155 mph/250 km/h, the system is deactivated
temporarily.
If the vehicle speed falls below approx.
155 mph/250 km/h, the system once again re‐
sponds according to the setting.
Functional limitations
The system may not be fully functional in the fol‐
lowing situations:
▷ When a vehicle is approaching at a speed
much faster than your own.
▷ In heavy fog, wet conditions, or snowfall.
▷ In tight curves or on narrow lanes.
▷ If the bumper is dirty, iced up, or covered,
for instance by stickers.
▷ If cargo protrudes.
For vehicles with side collision warning, the
steering intervention can be limited, for instance
in the following situation:
▷ In the event of missing, worn, poorly visible,
merging, diverging, or multiple lane markings
such as in construction areas.
▷ When lane markings are covered in snow, ice,
dirt or water.
▷ When the lane markings are not white.
▷ When the lane markings are covered by ob‐
jects.
▷ When driving very close to the vehicle in front
of you.
▷ If there are constant blinding effects because
of oncoming light, for instance from the sun
low in the sky.
▷ If the field of view of the camera or the wind‐
shield is dirty or covered in the area of the in‐
terior mirror.
▷ If the camera has overheated and been tem‐
porarily switched off due to excessively high
temperatures.
▷ Up to 10 seconds after the start of the engine
via the Start/Stop button.
▷ During calibration of the camera immediately
after vehicle delivery.
A Check Control message is displayed when the
system is not fully functional.
Displaying warnings
Depending on the selected warning settings, for
instance warning time, more warnings can be
displayed. However, there may also be an excess
of premature warnings of critical situations.
Seite 187
Safety
CONTROLS
187
Online Edition for Part no. 01402722630 - VI/18
Loading ...
Loading ...
Loading ...