Loading ...
Loading ...
Loading ...
Lights and visibility
Note
●
The vehic
le battery will discharge and run
down if the hazard warning lights remain on
for too long (even with the ignition turned
off).
●
In some vehicles, the brake lights will flash
when braking abruptly at speeds of approxi-
mately 80 km/h (50 mph) to warn vehicles
travelling behind. If braking continues, the
hazard warning lights system will automati-
cally be turned on at a speed of less than ap-
proximately 10 km/h (6 mph). The brake
lights remain lit. Upon accelerating, the haz-
ard warning lights will be automatically
turned off.
Adhesive strips for headlights or ad-
ju
s
tin
g headlights
In those countries where vehicles drive on
the other s
ide of
the r
oad to the home coun-
try, the asymmetric dipped beam may dazzle
drivers of oncoming vehicles. Therefore,
when driving abroad, adhesive strips should
be attached to the headlights or the head-
lights should be adjusted accordingly.
The direction of the headlights can be adjus-
ted from the instrument panel, in the Tou-
rist light submenu of the Configura-
tion menu
›››
page 30.
For those vehicles in which it is not possible
to adjust the headlights from the menu, ad-
hesive strips are used to cover certain parts
of the headlamp cover or the headlights may
be adjusted at a specialised workshop. For
further information, please refer to a special-
ised workshop. SEAT recommends visiting a
technical service.
Note
Use of the Tourist light option and the
adhes
ives on the headlights is only allowed if
they are to be used for a short period of time.
To modify the direction of the headlights per-
manently, please take the vehicle to a speci-
alised workshop. SEAT recommends visiting a
technical service centre.
Headlight range control, lighting of
the in
s
trument
panel and controls
Fig. 142 Next to the steering wheel: instru-
ment
and sw
it
ch lighting control
1
and
he
a
dlight
range control
2
1
Instrument and switch lighting
When the he
a
dlights
are switched on, the
brightness of the instruments and switch
lighting can be regulated by turning the
switch ››› Fig. 142
1
.
2
Headlight range control
The he
a
dlight
range control ››› Fig. 142
2
is
modified ac
c
or
ding to the value of the head-
light beam and the vehicle load status. This
offers the driver optimum visibility and the
headlights do not dazzle oncoming drivers
›››
.
The he
a
dlights
can only be adjusted when
the dipped beam is switched on.
To reset, turn switch ››› Fig. 142
2
:
Value Vehicle load status
a)
–
Two front occupants, luggage compart-
ment empty
1
All seats occupied, luggage compartment
empty
2
All seats occupied, luggage compartment
full With trailer and minimum drawbar load
3
Driver only, luggage compartment full With
trailer and maximum drawbar load
a)
If the vehicle load does not correspond to those shown in the
table, it is possible to select intermediary positions.
»
135
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...