Loading ...
Loading ...
Loading ...
Cleaning and Maintenance
60
What to do if...
The display is completely off:
• Check the main power supply.
• Check whether an omnipolar switch
upstream from the oven feed line is in the
“ON” position.
The appliance doesn’t heat up:
• Check whether the “demo” mode has
been set (for further details see the
“Settings” section).
The controls do not respond:
• Check whether the “control lock” mode
has been set (for further details see the
“Settings” section).
The cooking times are longer than those
indicated in the table.
• Check whether the “eco-logic” mode
has been set (for further details see the
“Settings” section).
After the automatic “pyrolytic” self-cleaning
cycle it is not possible to select a function:
• Check whether the interlock device has
been switched off. If it has not, the oven
has a safety device that does not allow
functions to be selected while the
interlock device is active. This is because
the inside of the oven is still very hot and
cannot be used for cooking yet.
The display shows “Error 4”.
• The door interlock device has not
properly hooked to the door. This might
be because the door was accidentally
opened during its activation. Switch off
the oven and switch it on again, waiting
a few minutes before selecting a new
cleaning cycle.
If the door is opened during a convection
function, the fan stops:
• This is not a fault. It is a normal operation
of the appliance, useful when cooking
foods in order to avoid excessive heat
from escaping. When the door is closed,
the oven will return to normal operation.
If the problem has not been
resolved or there are other types of
faults, contact your local technical
assistance center.
If other “ERRx” error messages
appear:
Note the error message, function
and temperature set and contact
Customer Service.