Loading ...
Loading ...
Loading ...
ENGLISH
11
BEFORE USING THE ROBOT CLEANER
Charging
Before Charging the Battery
• Charging takes place even if the main power
switch of the robot cleaner is turned off.
• The charging time depends on the status of the
battery.
• It takes approximately 4 hours to fully charge
the battery after it is completely discharged.
• Clean the charging terminals using a soft cloth.
If the charging terminals are dirty or covered
or obstructed with foreign material, the robot
cleaner may not be charged normally.
• Charging may not take place if the ambient
temperature is below 41°F (5°C). Charge the
robot cleaner indoors.
• If it is necessary to store the robot cleaner for
a long period of time, fully charge the battery
every 6 months.
• Storing the robot cleaner for a long period of
time without periodically charging the battery
may cause a battery malfunction.
• If cleaning is not started from the home station
or you lift and move the robot cleaner, it may
take a longer time to find the home station.
Battery Level Indicator
• The battery level is indicated on the control
panel, as follows.
− The remaining battery level is displayed in
3 stages (
r s t
) according to the
amount of power remaining.
− The battery level indicator flashes when the
robot cleaner needs to be charged.
− The battery level indicator flashes while
recharging is in progress, showing the battery
level.
− If recharging is complete, the battery level
indicator turns on.
Inserting Batteries into the Remote
Control
1
Release the tab at the back of the remote
control to open the battery cover.
2
Insert two AAA batteries into the remote
control.
• Make sure the + and - ends of the batteries
are aligned properly.
3
Insert the bottom of the battery cover into the
remote control and close the cover.
Installing the Home Station
1
Remove the protective film attached to the
home station, the robot cleaner, and the
nozzle.
• If the protective film is not removed, the robot
cleaner may have difficulty finding the home
station or it may affect performance.
2
Position the home station on a hard, level floor
to prevent sliding during docking.
• Locate the home station where there are no
obstacles within 5 ft (1.5 m) of either side and
within 6.5 ft (2 m) of the front.
1.5 m
1.5 m
2 m
Loading ...
Loading ...
Loading ...