Loading ...
Loading ...
Loading ...
18
ArtNo.311-0014 Wok burner details
A
B
C
D
E
ArtNo.311-0016 Fitting the burner inner head
A
B
Fig.6-2
Fig.6-4
The Wok Burner
When reassembling the wok burner (Fig.6-2) turn over the
large base ring and nd the ‘D’ shaped area (Fig.6-3). Turn the
head until the ‘D’ matches the one on the burner base. Flip
the burner over once again and place it on the burner base.
To t the small inner burner, nd the larger electrode notch
in the burner rim. Line this up with the ignition electrode and
place the inner burner on the large base ring (Fig.6-4).
Now t the two burner caps, ensuring that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
Griddle
Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
The Wok Cradle
Recommended cleaning materials are hot soapy water, a
moistened soap pad, cream cleaner or nylon scourer.
Main Top
Lift away pots or pans from the main top. Remove the pan
supports from the spillage area and carefully place in a sink
of warm soapy water. Wipe loose debris from the main top.
For best results use a liquid detergent cleaner. Rinse with cold
water and thoroughly dry with a clean, soft cloth. Ensure all
parts are dry before repositioning.
Avoid using any abrasive cleaners including cream
cleaners on brushed stainless steel surfaces.
Never use caustic or abrasive cleaners as these will
damage the surface.
Control Panel and Oven Doors
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Removing the oven door outer panel
The outer door panel can be removed so that the inside of
the glass can be cleaned. Undo the 4 screws (2 each side)
in the door (Fig.6-5). Open the door slightly and, using the
handle, carefully lift the door outer upwards.
Ret in reverse.
A – Inner burner cap, B – Outer burner cap, C – Inner burner head,
D – Outer burner head, E – Wok burner base
ArtNo.311-0015 Burner alignment
‘D’
Fig.6-3
A – Electrode notch, B – Ignition electrode
ArtNo.272-0015 - 90DF - Pro+ - Removing the outer door panel
Fig.6-5
Loading ...
Loading ...
Loading ...