Loading ...
Loading ...
Loading ...
3. Push the programmed HomeLink button to
confirm that the garage door opener motor
operates. If the garage door opener motor
does not operate, repeat the final steps for
the rolling code procedure.
Non-Rolling Code Garage Door Opener
Final Steps
1. Push and hold the programmed HomeLink
button and observe the HomeLink indicator
light. If the HomeLink indicator light stays
on constantly, programming is complete.
2. Push the programmed HomeLink button to
confirm that the garage door opener motor
operates. If the garage door opener motor
does not operate, repeat the steps from the
beginning.
WARNING!
• Y our motorized door or gate will open and
close while you are programming the uni-
versal transceiver. Do not program the
transceiver if people or pets are in the path
of the door or gate.
WARNING!
• Do not run your vehicle in a closed garage
or confined area while programming the
transceiver. Exhaust gas from your vehicle
contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is
poisonous when inhaled and can cause
you and others to be severely injured or
killed.
Programming HomeLink To A
Miscellaneous Device
Refer to “Programming HomeLink To A Garage
Door Opener” for the procedure on how to pro-
gram HomeLink to a miscellaneous device, as it
follows the same procedure. Be sure to deter -
mine if the device has a rolling code, or non-
rolling code before beginning the programming
process.
NOTE:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal
during programming. Similar to this Canadian
law, some U.S. gate operators are designed to
time-out in the same manner. The procedure
may need to be preformed multiple times to
successfully pair the device to your HomeLink
buttons.
Reprogramming A Single HomeLink Button
To reprogram a single HomeLink button that has
been previously trained, without erasing all the
channels, follow the procedure below. Be sure
to determine whether the new device you want
to program the HomeLink button to has a Roll-
ing Code, or Non-rolling Code.
1. Cycle the ignition to the ON/RUN position,
without starting the engine.
2. Push and hold the desired HomeLink button
until the HomeLink Indicator light begins to
flash after 20 seconds. Do not release the
button.
GETTING TO KNOW YOUR VEHICLE
44
Loading ...
Loading ...
Loading ...