Loading ...
Loading ...
Loading ...
To Turn Off The Engine Using
ENGINE START/STOP Button —
Manual Transmission Only
1. With the vehicle stopped, place the gear
selector in NEUTRAL, then push and release
the ENGINE START/STOP button.
2. The ignition will return to the OFF mode.
3. Place the gear selector in first gear or RE-
VERSE and then apply the parking brake.
NOTE:
• If the ignition switch is left in the ACC posi-
tion, the system will automatically time out
after 30 minutes of inactivity and the ignition
will switch to the OFF position.
• If the ignition switch is left in the RUN posi-
tion, the system will automatically time out
after 30 minutes of inactivity if the vehicle
speed is 0 mph (0 km/h) and the engine is not
running.
• If the vehicle speed is above 5 mph (8 km/h),
the ENGINE ST AR T/STOP button must be
held for two seconds or three short pushes in a
row before the engine will shut off. The igni-
tion switch position will remain in the ACC
position until the vehicle is stopped, placed in
park and the button is pushed twice to the
OFF position.
To Turn Off The Engine Using
ENGINE START/STOP Button —
Automatic Transmission Only
1. Place the gear selector in P ARK, then push
and release the ENGINE STAR T/STOP
button.
2. The ignition will return to the OFF mode.
3. If the gear selector is not in PARK, the
ENGINE ST AR T/STOP button must be held
for two seconds or three short pushes in a
row with the vehicle speed above 5 mph
(8 km/h) before the engine will shut off. The
ignition will remain in the ACC mode until
the gear selector is in P ARK and the button
is pushed twice to the OFF mode. If the gear
selector is not in P ARK and the ENGINE
START/STOP button is pushed once, the
instrument cluster will display a “Vehicle
Not In Park” message and the engine will
remain running. Never leave a vehicle out of
the PARK position, or it could roll.
NOTE:
If the ignition switch is left in the ACC or RUN
(engine not running) position and the transmis-
sion is in P ARK, the system will automatically
time out after 30 minutes of inactivity and the
ignition will switch to the OFF position.
ENGINE BREAK-IN
RECOMMENDATIONS
For vehicles equipped with the 3.6L or 5.7L use
the following engine break-in recommenda-
tions:
A long break-in period is not required for the
drivetrain (engine, transmission, clutch, and
rear axle) in your new vehicle.
Drive moderately during the first 300 miles
(500 km). After the initial 60 miles (100 km),
speeds up to 50 or 55 mph (80 or 90 km/h) are
desirable.
While cruising, brief full-throttle acceleration
within the limits of local traffic laws contributes
to a good break-in. However , wide-open throttle
acceleration in low gear can be detrimental and
should be avoided.
109
Loading ...
Loading ...
Loading ...