Loading ...
Loading ...
Loading ...
• If the button is continually pushed, the set
speed will continue to decrease in 10 km/h
decrements until the button is released. The
decrease in set speed is reflected in the in-
strument cluster display.
NOTE:
• When you override and push the SET (+)
button or SET (-) buttons, the new set speed
will be the current speed of the vehicle.
• When you use the SET (-) button to deceler-
ate, if the engine’ s braking power does not
slow the vehicle sufficiently to reach the set
speed, the brake system will automatically
slow the vehicle.
• The ACC system applies the brake down to
15 mph (24 km/h) when following a target
vehicle.
• The ACC system maintains set speed when
driving up hill and down hill. However, a slight
speed change on moderate hills is normal. In
addition, downshifting may occur while
climbing uphill or descending downhill. This
is normal operation and necessary to maintain
set speed. When driving up hill and down hill,
the ACC system will cancel if the braking
temperature exceeds normal range
(overheated).
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot from
the accelerator pedal. The instrument cluster
display will display the last set speed.
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in-front of your vehicle in close
proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to fol-
low these warnings can result in a collision
and death or serious personal injury.
Deactivation
Push and release the Adaptive Cruise Control
(ACC) on/off button a second time to turn the
system off.
“Adaptive Cruise Control (ACC) Off” will appear
in the instrument cluster display to indicate the
ACC is off.
WARNING!
Leaving the ACC system on when not in use is
dangerous. Y ou could accidentally set the
system or cause it to go faster than you want.
You could lose control and have an accident.
Always leave the system OFF when you are
not using it.
Setting The Following Distance
The specified following distance for ACC can be
set by varying the distance setting between four
bars (longest), three bars (long), two bars (me-
dium) and one bar (short). Using this distance
setting and the vehicle speed, ACC calculates
and sets the distance to the vehicle ahead. This
distance setting appears in the instrument clus-
ter display.
123
Loading ...
Loading ...
Loading ...