Loading ...
Loading ...
Loading ...
En
6
Part names and functions
Rear panel, front panel
PHONES
LINK
CH4
EXTENSION
CH3 CH2CH1
IN
OFFON
75
Ω
MASTER2
REC OUT
MASTER1
WORD CLOCK
DIGITAL OUT
INTERNET
DIGITAL IN
BOOTH
AES/EBU
2 4
5 4554 54 6
61
7 8
k
9
gh c bd
j
a
fi e
3
1 Kensington security slot
2 POWER button (page 17 )
Turns this unit’s power on and off.
3 EXTENSION terminal (page 15 )
Used when extending PRO DJ LINK. Connect this to the LAN termi-
nal of a computer with rekordbox installed, etc.
4 PHONO terminals (page 15 )
Connect to a phono level (MM cartridge) output device. Do not input
line level signals.
To connect a device to the [PHONO] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [PHONO] terminals when
nothing is connected to them to cut external noise.
5 LINE terminals (page 15 )
Connect to a DJ player or a line level output component.
6 SIGNAL GND terminal (page 15 )
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
7 MIC2 terminal (page 15 )
Connects a microphone here.
8 MIC1 terminal (page 15 )
Connects a microphone here.
9 INTERNET terminal
Connect to a router, etc. that is connected to the Internet. Used when
connecting with the KUVO system.
Connect a device to be connected to PRO DJ LINK not to this termi-
nal but to the [EXTENSION] terminal.
a DIGITAL IN terminal (page 15 )
Connect these to the digital coaxial output terminals on DJ players,
etc. The sound may be momentarily interrupted when the output
signal sampling frequency is switched.
b 75 Ω termination ON/OFF switch
c WORD CLOCK input terminal
Set the external clock generator to MASTER and implement digital
master output synchronized with another device.
Use a cable with an impedance of 75 Ω for the connection between
the terminals. Performance is not guaranteed when a cable with an
impedance of other than 75 Ω is used.
Change the 75 Ω termination ON/OFF switch setting according to
the connection method.
— ON
— For connecting with the external clock generator on a one-to-
one basis
— For terminating with this unit when connecting a combina-
tion of multiple devices
— OFF
— For terminating with another device when connecting a
combination of multiple devices
Loading ...
Loading ...
Loading ...