Loading ...
Loading ...
Loading ...
When you are pressing the ignition
switch, or when the ignition switch is
in the ON (II) position, the beeper
sounds if you take the remote out of
the vehicle and close the door.
To remove the ignition switch cover,
insert the built-in key (see page ),
then pull the cover out by pulling the
built-in key while pushing it.
When the beeper sounds after you
close the driver’s door outside the
vehicle, check the position of the
ignition switch and the location of
the remote.
If the engine is running and you
removetheremotefromthevehicle,
it will continue to run. But once
turned to the LOCK (0) position, the
engine will not restart until a remote
is brought back into the vehicle.
141
Keyless Access System
Beeper and MessageRemoving the Ignition Switch
Cover
Keyless Remote Not Detected
138
BUILT-IN KEY
IGNITION SWITCH COVER
push
pull
Main Menu
Main Menu
Table of Contents
Loading ...
Loading ...
Loading ...