Loading ...
Loading ...
Loading ...
23
Before Installation
Before Installation
■ Do Not Touch the Lens with Bare Hands
■ Allow a 30 Min. Warm Up before Focus Adjustment (P59), if Possible
The focus position may not stabilize immediately after startup, due to lamp heat.
When adjusting focus, it is also helpful to use the test pattern (10) (P115, P187).
■ Install at a Sufficient Distance from Walls and Other Obstructions
■ Be Careful of Condensation
If the temperature of the room rises suddenly, moisture in the air may condense on
the projector lens and mirror, causing the image to become blurred. Wait until the
condensation has evaporated for the image projected to return to normal.
■ At Altitudes above 2,300 m (7,545.8'), Adjust the Settings
Projector settings must be adjusted when using the projector at altitudes of 2,300 m
(7,545.8') or higher. Specifically, refer to instructions for [Fan mode] (P108) in the
[Install settings] menu.
• Do not touch the lens with bare hands. Any smudges or
fingerprints on the lens may affect image quality.
If the air intake or exhaust
vent is blocked, heat will
accumulate inside the
projector, possibly resulting in
a shortened projector lifetime
or a malfunction.
Similarly, do not install in
narrow, enclosed spaces with
poor ventilation. Install in a
well-ventilated location.
Ensure a minimum clearance of 50 cm (1.6 ft.) above, on both
sides, and behind the projector, as shown below.
Exhaust vent
Air intake vent
Warmed
airflow
50cmà»è„
At least
50 cm (1.6')
At least
50 cm (1.6')
At least
50 cm (1.6')
At least
50 cm (1.6')
Loading ...
Loading ...
Loading ...