Loading ...
Loading ...
Loading ...
20
16.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“7. Turning o”);
2. Remove the water tank (A16) (g. 3);
37 38
PUSH
PUSH
3. Open the infuser door (A18) (g. 37) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 38);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 39), then push the PUSH symbol fully
in until it clicks into place;
39 40
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 40.
41
PUSH
8. Once inserted, make sure
the two coloured but-
tons have snapped out
(g. 41);
9. Close the infuser door;
10. Put the water tank back.
16.10 Cleaning the milk container
To keep the frother ecient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (g. 42);
3. Turn the froth adjustment dial (D1) anticlockwise to the
“INSERT” position (g. 42) and pull it o upwards;
42
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwasher
safe, placing them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (g. 43). If necessary, scrape the
groove with a toothpick;
Loading ...
Loading ...
Loading ...