Loading ...
Loading ...
Loading ...
26 INSTALLATION
Installation Test (Duct Check)
Once you have completed the installation of the
dryer, use this test to make sure the condition of the
exhaust system is adequate for proper operation of
the dryer. This test should be performed to alert you
to any serious problems in the exhaust system of
your home.
• Your dryer features Flow Sense™, an innovative
sensing system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces
energy use.
NOTE
• The dryer should be cool before starting this test. If
the dryer was warmed up during installation, run the
Air Dry cycle for a few minutes to reduce the interior
temperature.
Activating the Installation Test
1
Remove the literature and parts package
(and the drying rack if included), and close
the door.
Do not load anything in the drum for this test, as
it may affect the accuracy of the results.
2
Press and hold the Temp. and Signal buttons
and then press the POWER button.
(On models with a glass touch control panel,
press the POWER button then IMMEDIATELY
press and hold the Temp. and Signal buttons.)
This button sequence activates the installation
test. The code
will display if the activation
is successful.
3
Press the START/PAUSE button.
The dryer will start the test, which will last about
a few minutes. The heat will be turned on and
the temperatures in the drum will be measured.
4
Check the display for results.
During the test cycle, monitor the Flow Sense™
display on the control panel. If no bars are
displayed when the cycle ends, the exhaust
system is adequate. If the exhaust system is
severely restricted, the display will show four
bars. Have the system checked immediately, as
performance will be poor. Other problems may
also be shown with error codes. Refer to the the
Error Code table for details and solutions.
NO BARS: OK FOUR BARS:
RESTRICTED
5
End of cycle.
At the end of the test cycle,
will display.
The test cycle will end and the dryer will shut off
automatically after a short delay.
Loading ...
Loading ...
Loading ...