Loading ...
Loading ...
Loading ...
14 www.aeg.com
The vacuum
cycle is stopped
within a few
seconds and
the button
ashes.
The cover gasket is dirty or worn. Clean or replace the gasket of the
cover and check that it is closed
properly.
Alarm messages
Alarm Possible cause Solution
The button will
ash continuously.
The electrical board is faulty. Contact the Technical Assistance
Service.
The button will
ash continuously.
The vacuum is not produced. Clean or replace the cover gasket
(contact the Technical Assistance
Service to replace it).
Make sure the cover closes
correctly.
Press the button to reset the
alarm.
The and
buttons ash
continuously.
The pump oil must be replaced. Contact the Technical Assistance
Service.
The
button ashes
continuously.
The packaging cycle is
terminated in advance
because a wet product is being
packaged.
Press the button to reset the
alarm.
8.2 Assistance Data
If it is not possible to nd a solution to
the problem, contact the authorised
Assistance Centre.
The information required for the
Assistance Centre is found on the data
plate on the left side of the appliance. Do
not remove the data plate.
9. ENVIRONMENTAL CONSIDERATIONS
Recycle materials that carry this
symbol .
Dispose of the packaging in special
containers for recycling. Help protect
the environment and human health and
recycle waste deriving from electric and
electronic devices.
Do not dispose of appliances that carry
this symbol together with domestic
waste.
Return the product to your local recycling
facility or contact your municipal oce.
Loading ...
Loading ...
Loading ...