Loading ...
Loading ...
Loading ...
KEYLESS ENTER-N-GO — IGNITION
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery. In this situation, a back up method can be used to operate the
ignition switch. Put the nose side of the key fob (side opposite of the Emergency Key)
against the ENGINE ST ART/STOP button and push to operate the ignition switch.
Starting
1. Place the gear selector in P ARK or
NEUTRAL.
2.
While pushing the brake pedal, push the
ENGINE ST AR T/STOP button once. If the
engine fails to start, the starter will disen-
gage automatically after 10 seconds.
3. To stop the cranking of the engine prior
to the engine starting, push the button
again.
Stopping
1. Place the gear selector in PARK.
2. Push the ENGINE ST AR T/STOP button
once. The ignition switch will return to
the OFF position.
If the gear selector is not in P ARK, the ENGINE ST AR T/STOP button must be held for two
seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.
NOTE:
If the ignition switch is left in the ACC or RUN (engine not running) position and the
transmission is in PARK, the system will automatically time out after 30 minutes of
inactivity and the ignition will switch to the OFF position.
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver’s foot off of the Brake Pedal (transmission in
PARK).
Engine START/STOP Button
GETTING STARTED
19
Loading ...
Loading ...
Loading ...