Loading ...
Loading ...
Loading ...
En
18
Utilities mode
The following settings can be changed:
! Cut lag setting
! Disabling the demo mode
! Switching the back spin length
! Channel fader start setting
Launching the utilities mode
If the utilities mode is launched while the DJ application is running,
the set status may not be displayed properly.
1 Quit the DJ application on the computer.
2 Disconnect the USB cable from this unit.
Turn off the power of this unit.
! Do not disconnect the USB cable from the computer.
3 Connect the USB cable to this unit while pressing
both the SHIFT button and [f] (PLAY/PAUSE)
button on the left deck.
The utilities mode is launched.
4 After setting the utilities mode, operate the
controller for the items whose settings you want to
change.
See the explanations below for the settings that can be changed.
5 Disconnect the USB cable connecting this unit to
the computer and save the settings.
To save the settings, this unit’s power must be turned off.
Changing the settings
Adjusting the cut lag of the crossfader
Adjust the cut lag on both edges of the crossfader. Cut lag can be
adjusted from 0 (0.5 mm) to 52 (5.7 mm), by 0.1 mm units.
! Default setting is 5 (1.0 mm).
Turning the rotary selector
Display the current value (0 to 52) by the lighting status of the channel
level indicator and performance pads.
! Lighting number of the [CH2] channel lever indicator: units 0 to 5
! Lighting number of the [CH1] channel lever indicator: units 6 to 9
! Lighting number of the performance pad on the right deck: tens 0 to
5
Disabling the demo mode
On this unit, the demo mode is set if no operation is performed for 10
minutes under normal usage conditions. This demo mode can be turned
off.
! By default, the demo mode is on.
! When any control or button on this unit is operated while in the
demo mode, the demo mode is canceled.
Launch the utilities mode and press the [HOT CUE
(BEAT JUMP)] button on the left side.
— [HOT CUE (BEAT JUMP)] button lit: Demo mode enabled
— [HOT CUE (BEAT JUMP)] button off: Demo mode disabled
Changing the back spin length
This unit can perform back spin longer than the actual jog dial rotation
amount when the back spin operation of the jog dial is performed.
The length of back spin can be selected from one of three types: short,
normal, and long.
! The default back spin length is set to normal.
Launch the utilities mode, then press one of the
buttons of the left deck’s pads 5, 6 or 7.
— Pad 5 button lit: Back spin length short
— Pad 6 button lit: Back spin length normal
— Pad 7 button lit: Back spin length long
Changing the fader start setting
The fader start function’s setting can be changed.
! By default, the fader start mode functions without the sync mode set.
Launch the utilities mode, then press one of the
buttons of the left deck’s pads 1, 2 or 3.
— Pad 1 button lit: Fader start with the sync mode set (The sync
function is activated simultaneously when the fader starts.)
— Pad 2 button lit: Fader start without the sync mode set (The sync
function is not activated when the fader starts.)
— Pad 3 button lit: Fader start function disabled
Loading ...
Loading ...
Loading ...