Loading ...
Loading ...
Loading ...
En
15
Advanced operation
Advanced operation
From here, this guide explains the unique function when this unit and
Serato DJ Lite are connected. This is not explained in the Serato DJ
Lite software manual.
Five modes are available for the DDJ-SB3 pads.
Pad mode
Controls the hot cue, FX fade, pad scratch, sampler and TRANS
functions.
To switch a function, press the pad mode buttons.
Using hot cues
Playback can be started from the position at which a hot cue is set.
! Up to four hot cue points can be set and saved per track.
1 Press the [HOT CUE (BEAT JUMP)] mode button.
Lights the [HOT CUE (BEAT JUMP)] mode button and switches to the
hot cue mode.
2 In the play or pause mode, press a pad to set the
hot cue point.
The hot cue points are assigned to the respective pads as shown below.
Hot cue 1
Previous
track
Hot cue 3Hot cue 2
Search
Search
Hot cue 4
CENSOR
3 Press the pad at which the hot cue point was set.
Playback starts from the hot cue point.
! Hot cue points can be cleared by pressing a pad while pressing
the [SHIFT] button.
Using the FX fade
The sound of the track changes as time goes by.
1 Press the [FX FADE (ROLL)] mode button.
Lights the [FX FADE (ROLL)] mode button and switches to the FX fade
mode.
2 Press the pad during the playback and turn on the
FX fade.
The FX fade types are assigned to the respective pads as shown below.
Filter
fade 2
Filter
fade 1
Filter
fade 4
Filter
fade 3
Loop
fade 2
Loop
fade 1
Back
spin 2
Back
spin 1
3 Press the pad again to turn off the FX fade.
FX fade is turned off even when the pad mode is changed.
Using the pad scratch
The scratch operation is possible with the hot cue 1 point as the starting
point.
1 Press the [PAD SCRATCH (SLICER)] mode button.
Lights the [PAD SCRATCH (SLICER)] mode button and switches to the
pad scratch mode.
2 Press the pad to perform scratching.
The scratch types are assigned to the respective pads as shown below.
Scratch 1
Scratch 5
Scratch 3
Scratch 7
Scratch 2
Scratch 6
Scratch 4
Scratch 8
Using the sampler function
This procedure can be used to play tracks loaded in the sampler’s
sampler slots using the pads.
1 Click (sample) on the computer screen to open
the
(sample) panel.
2 Press the [SAMPLER (TRANS)] mode button.
Lights the [SAMPLER (TRANS)] mode button, and switches to the
sampler mode.
3 Drag and drop the track by the mouse operation
on the computer screen, and load the track to each
slot of the (sample) panel.
Sampler setting and loaded track are stored.
4 Press the pad.
Plays the sound in the slot assigned to the pressed pad, or changes the
playback position.
Slot 1 Slot 3Slot 2 Slot 4
CENSOR
Previous
track
Search
Search
! When pressing the pad while pressing the [SHIFT] button, sound of
the slot which is playing back is stopped or the playback position is
changed.
Loading ...
Loading ...
Loading ...