Loading ...
Loading ...
Loading ...
En
10
Connections
Before connecting to the device or changing the connection, disconnect the USB cable. Only use the USB cable included with this unit.
Refer to the operating instructions for the component to be connected.
Power is supplied by the USB bus power. You can use the unit with only connecting to your computer.
Connect the connecting cable correctly after checking the place of the terminal on this unit.
! Connect the unit and your computer directly using the included USB cable.
! A USB hub cannot be used.
! Connect your computer connected with this unit to an AC power supply.
! This unit may not be used with the USB bus power in the following situation.
— Power supply capacity of the USB terminal on your computer is too low.
— Your computer is connected with other devices.
— Impedanceoftheheadphonesislowerthan32Ω.
— The [PHONES] output terminal is connected with a monaural jack.
Connecting input/output terminals
Rear panel
Speakers with a built-in
amplifier, powered
speakers, etc.*
1,
*
2
Microphone*
3,
*
4
*
1
An audio cable (RCA) is not included with this unit.
*
2
Turn the volume of the device(s) (speakers with a built-in amplifier,
powered speaker, etc.) connected to the [MASTER] output terminals
to an appropriate level. Note that the output sound may be loud if the
volume is set too high.
*
3
Only unbalanced input is supported for [MIC] input terminal.
*
4
When not using a microphone, turn the [MIC LEVEL] control to the
minimum level.
Front panel
Headphones
Connecttheheadphoneshavinganimpedanceof32Ωormore.
Headphoneswithanimpedancelowerthan32Ωarenotsupported.
Connecting your computer to the
unit
1 Connect your computer to the unit via a USB cable.
Make a direct connection with the supplied USB cable for optimum
performance. A USB hub cannot be used.
USB cable (supplied)
Computer
2 Turn on your computer.
3 Turn on the device(s) (speakers with a built-in
amplifier, powered speakers, etc.) connected to the
output terminal.
Loading ...
Loading ...
Loading ...