Loading ...
Loading ...
Loading ...
En
17
Advanced operation
Example of operation
1 Set the effect level to 0 % (set at the fully counterclockwise
position).
Turn the first effect on.
2 While gradually raising the effect level, turn the second effect on.
3 While further raising the effect level, turn the third effect on.
4 Raise the effect level to 100 % (set at the fully clockwise position).
Finally, turn all three effects off.
1 2 3 4
Effect
level
1 Select the effect type.
Press the effect 1 button while pressing the [SHIFT] button to select the
first effect type.
2 Operate an effect level control to adjust the effect
level.
In this example, the effect level control is set at the fully
counterclockwise (0 %) position.
3 Press the effect 1 button to turn the first effect on.
The first effect turns on.
4 Operate an effect level control to adjust the effect
level.
Turn the effect level control gradually clockwise to raise the effect level.
With this operation, only the first effect is active.
5 Press the effect 2 button to turn the second effect
on.
The first and second effects are now on simultaneously.
6 Operate an effect level control to adjust the effect
level.
Turn the effect level control a little more clockwise to raise the effect
level.
With this operation, both the first and second effects are active.
7 Press the effect 3 button to turn the third effect
on.
The three effects are now on simultaneously.
8 Operate an effect level control to adjust the effect
level.
Turn the effect level control a little more clockwise to raise the effect
level.
With this operation, all three effects are active.
9 Turn the effects off.
Press the effect 1 button to turn the first effect off.
Press the effect 2 button to turn the second effect off.
Press the effect 3 button to turn the third effect off.
! When multiple effects are on, their respective effect levels are the
same.
Effect levels cannot be adjusted individually.
Mixing the sound of the
microphone
1 Connect the microphone to the [MIC] input
terminal (1/4” TS jack).
2 Start up the system.
= “Starting the system” (page 12)
3 Turn the [MIC LEVEL] control.
This adjusts the output audio level.
Be aware that rotating to the extreme right position outputs a very loud
sound.
Analyzing tracks
When one of this unit’s [LOAD] buttons is pressed and tracks are loaded
onto the decks, the tracks are analyzed, but some time may be required
until analysis is completed and the BPM and waveform are displayed.
When the Serato DJ Lite software is used as an offline player, tracks can
be analyzed beforehand. For tracks whose analysis has been completed,
the BPM and waveform are displayed immediately when the tracks are
loaded onto the decks.
For details on using the Serato DJ Lite software as an offline player and
instructions on analyzing tracks, refer to the Serato DJ Lite software
manual.
! Depending on the number of tracks, some time may be required for
analysis.
Loading ...
Loading ...
Loading ...