Loading ...
Loading ...
Loading ...
Chevrolet BOLT EV Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
13556250) - 2020 - CRC - 2/11/20
12 Keys, Doors, and Windows
Programming with Two
Recognized Transmitters
A new transmitter can be
programmed to the vehicle when
there are two recognized
transmitters. To program, the vehicle
must be off and all of the
transmitters, both currently
recognized and new, must be
with you.
1. Open the center console and
take out the small tray,
if equipped. Place the two
recognized transmitters in the
backup location with the
buttons facing down.
2. Remove the key lock cylinder
cover on the driver door
handle. See Door Locks 0 17.
Insert the vehicle key of the
new transmitter into the key
lock cylinder on the driver door
handle and turn the key to the
unlock position five times within
10 seconds.
The DIC displays READY FOR
REMOTE # 3, 4, 5, 6, 7, or 8.
3. Place the transmitter to be
programmed in the backup
location with the buttons
facing down.
4. Press POWER
O to start the
vehicle. When the transmitter is
learned, the DIC will show that
it is ready to program the next
transmitter.
5. Remove the transmitter from
the backup location and press
K or Q.
To program additional
transmitters, repeat Steps 3–5.
When all additional transmitters
are programmed, press and
hold POWER
O for 12 seconds
to exit programming mode.
6. Put the key back into the RKE
transmitter.
7. Replace the key lock cylinder
cap. See Door Locks 0 17.
Programming without Two
Recognized Transmitters
If two currently recognized
transmitters are not available, follow
this procedure to program up to
eight transmitters. This feature is
not available in Canada. This
procedure will take approximately
30 minutes to complete. The vehicle
must be off and all of the
transmitters to be programmed must
be with you.
1. Remove the key lock cylinder
cover on the driver door
handle. See Door Locks 0 17.
Insert the vehicle key of the
transmitter into the key lock
cylinder on the driver door
Loading ...
Loading ...
Loading ...