#2 How to Level the Refrigerator?
Please Note: The information on this page is for Australian products only. Models, sequences, error codes or settings will vary depending on location and/or where the product had been purchased. To be redirected to your local support page please click here.
If your refrigerator is well levelled, you can avoid water leakage problems, cooling problems, noise problems (for a list of normal fridge noises, please click here), and damage to the refrigerator.
Please see the guide below for levelling your refrigerator.
Required Tools
tools needed to level
A carpenter's level is required to level the refrigerator left to right.
A flat-head screwdriver is required to turn the legs.
A Phillips screwdriver may be required if a kickplate needs to be removed.
Checking if the Refrigerator is Levelled
Using a carpenter's level, make sure the refrigerator is level left to right. Make sure to check the level of the main unit and not the doors (which can be adjusted separately).
If the refrigerator is not level, determine which side is higher, and on that side, rotate the levelling leg to the right and check the level again. Continue to adjust until the refrigerator is level.
Do not level the refrigerator front to back. When levelled correctly, the refrigerator will have a front-to-back slant, with the front of the refrigerator higher than the back.
Note:
When you push the refrigerator back in, make sure the rear legs rest on the panel.
If you have a wooden floor or similar soft floor, take care not to damage the floor when pushing the Refrigerator into place.
Locating the Levelling Legs
The levelling legs are located underneath the refrigerator at the front.
For easier access to the levelling legs on Side by Side and Four-Door models, open both doors.
If the refrigerator has a front leg cover, it needs to be removed for easier access to the levelling legs. This will vary between models, as some covers do not have to be removed to access the legs. To remove the front leg cover, remove the screws with a Phillips screwdriver, and then lift it up from the bottom and pull it out.
If you would like to ensure which design your refrigerator model has, you can refer to your enclosed user manual or download it from our Manuals & Downloads page.
location of the leveling legs
Adjusting the Levelling Legs
Insert a flat-head screwdriver into the slot in the levelling leg control lever and adjust the level by turning the control lever clockwise or counterclockwise.
When you rotate the Lever clockwise, you raise the refrigerator.
When you rotate the Lever counterclockwise, you lower the refrigerator.
adjust the leveling legs
If the refrigerator is not level back and front, put a solid panel (such as a plastic panel, a plastic ruler, etc.) on the floor where the rear legs will rest, and then fix it in place with plastic tape.
Once you have finished adjusting the levelling legs, check if it is properly levelled left to right with a level tool. When complete, do not forget to reinstall the front leg cover (if you removed one).