Loading ...
Loading ...
Loading ...
Performing Manual Drain
Pump Filter Cleaning
Care and Cleaning
With the wash tub
and drain hose
drained of all water
and the drain
spout snapped in
place, follow these
directions to remove,
clean, and reinsert
the pump filter.
1
2
1
2
In the event the washer will not drain under its
own power due to a power outage or clogged
drain pump you can drain the water left in the
drum manually.
180°
1
2
CAUTION
BURN HAZARD
Do not attempt to manually drain the drum
if it is full of hot water. Allow water to cool
before proceeding with manual draining.
2. Place a catch pan underneath the drain
pump filter to collect water as it drains.
3. Without removing the pump filter,
rotate the filter 180° counterclockwise to
allow the water to flow out into the catch
pan.
It may be necessary to close the filter and
drain the catch pan as it fills.
4. Repeat the process until all the water has
been drained.
NOTE
Always keep a rag nearby to clean any water
spills.
1. “Unscrew” the filter and pull it out.
2. Dump the filter and inspect the opening
for any loose objects.
3. Rinse the filter completely before putting it
back in place.
IMPORTANT
Check to make sure O-ring is in place
before reinserting pump filter. Take care to
not cross threads when turning pump filter
during reinsertion.
4. “Screw” filter back in place until it stops.
DO NOT overtighten.
5. Reinstall pump cleanout door if removed
earlier.
NOTE
You may have to add about 2 liters of clean
water through the mainwash detergent
compartment to reprime the drain pump.
pump filter cleanout
1. Remove pump cleanout door.
20
Loading ...
Loading ...
Loading ...