Loading ...
Loading ...
Loading ...
19
1
b Check the thickness of the material, and then
adjust the blade extension. See “Appropriate
Blade Extension” on page 18.
The larger the holder scale setting, the further the
blade extends.
a Turn to the left to decrease the blade extension.
b Turn to the right to increase the blade
extension.
Installing and Uninstalling the Holder
Install the holder in the machine.
a Press in the operation panel to turn on the
machine.
For details, see “Turning On/Off the Machine” on
page 10.
b If the holder lock lever is not raised, raise it.
The holder cannot be installed if the lever is lowered.
a Holder lock lever
c Grasp the holder grip, and then insert the
holder into the carriage.
a Grip
d Push down on the holder lock lever.
Firmly push down until the holder is locked in place.
e Reverse the installation procedure to uninstall
the holder.
Note
• After removing the blade holder from the
machine or when storing it, store the blade tip
within the holder.
Trial Cutting
Make sure that the blade extension is appropriate for
the material. Using the same material to cut or draw
on in your project, perform trial cutting.
■ Turning On the Machine
Press in the operation panel to turn on the machine.
• For details, see “Turning On/Off the Machine” on
page 10.
■ Setting the Holder
Install the cutting blade holder into the carriage of the
machine.
• For details, see “Installing and Uninstalling the
Holder” on page 19.
a
b
a
a
Loading ...
Loading ...
Loading ...