Loading ...
Loading ...
Loading ...
34
Fascia, controls and external surfaces
Do not use strong or abrasive cleaning agents or materials on the controls. fascia
panel or coloured cooker surfaces This can cause damage to the calibrations and
icons and permanently scratch the surfaces.
Coloured surfaces:
Clean with a sott cloth, warm water and washing-up liquid Whilst still damp, polish
dry with an microfibre cloth.
Stainless steel:
Far stubborn marks use a reputable non-abrasive stainless steel cleaner. Always
work with the grain of the stainless steel, rinse well and polish dry with an microfibre
cloth.
Glass:
Clean with a soft cloth, warm water and washing-up liquid. Difficult marks on the
glass can be removed using a cream cleaner. Never use sharp implements to
remove marks as this could scratch the glass.
Ovens:
Always allow the oven interior to cool before cleaning.
Interior oven door enamel and glass
Never use sharp implements to remove stains as this could scratch the surface. The
door enamel and glass surfaces can be cleaned with a soft cloth, warm water and
washing-up liquid. Polish dry with an microfibre cloth. For more stubborn marks and
to protect the glass surface use a good quality glass cleaner/conditioner, following
the manufacturer's instructions.
Please do not use steam cleaners on the oven interiors as thls may affect electronic
parts.
Ensure the cooker is cold before cleaning.
Removal of the oven door
To allow full access to the inside of the oven for thorough cleaning, the oven door
can be removed.
- Fully open the door and insert the pins supplied into each hinge.
- While closing the door to an angle of about 30°, lift and pull so that the door
leaves the mounting. Leave pins in place.
Removal of the inner glass door panes
To assist with cleaning, the inner glass door panes are removable.
- Open the door fully and insert the pms supplied into each hinge to secure the
door in an open
position.
-
Locate the stainless steel clips at the base of the door.
- Slide the clips towards the centre of the door.
- Holding the glass, lift slightly and pull towards the oven, the glass pane will
release.
- The central glass pane is revealed. This can be cleaned in situ or removed.
- To remove the central pane, remove the 4 screws and brackets.
- It is important to remember when replacing the central pane that the rubber
spacing must be replaced first.
- When replacing the inner pane, ensure the glass is print side up and the widest
Loading ...
Loading ...
Loading ...