Jenn-Air W10768190

User Manual - Page 23

For W10768190.

PDF File Manual, 48 pages, Download pdf file

Loading ...
Loading ...
Loading ...
23
Complete Installation (LP Gas to Natural Gas)
1. Refer to the “Make Gas Connection” section for proper
connection of the range to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition and operation.
3. Refer to the “Adjust Flame Height” section for burner ame
adjustments.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop burner ame is very important.
Natural gas ames do not have yellow tips.
4. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner ames. The cooktop “low”
burner ame should be a steady blue ame approximately ¼"
(6 mm) high. LP gas ames have a slightly yellow tip.
A
B
A. Low ame
B. High ame
To Adjust Standard Burner:
The ame can be adjusted using the adjustment screw
in the center of the valve stem. The valve stem is located
directly underneath the control knob.
If the “Low” Flame Needs to be Adjusted:
1. Light one burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
at-blade screwdriver to turn the screw located in the center
of the control knob stem until the ame is the proper size.
Turning the screw clockwise will increase the ame size,
and turning the screw counterclockwise will decrease
the ame size.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
3. Replace the control knob.
4. Test the ame by turning the control from the low position
to the high position, checking the ame at each setting.
5. Repeat the previous steps for each burner.
To Adjust Double Burner (On Some Models):
1. Light burner and turn to lowest setting where both inner
and outer burners are lit.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
at-blade screwdriver to turn the screw located in the center
of the control knob stem until the ame is the proper size.
Turning the screw clockwise will increase the ame size,
and turning the screw counterclockwise will decrease
the ame size.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
3. Replace the control knob.
4. Test the ame by turning the control from the low position
to the high position, checking the ame at each setting.
Loading ...
Loading ...
Loading ...