Jenn-Air W10768190 User Manual

Loading ...

Install Anti-Tip Bracket

1. Remove the anti-tip bracket from the inside of the oven.

2. Determine which mounting method to use: oor or wall.

If you have a stone or masonry oor, you can use the wall

mounting method. If you are installing the range in a mobile

home, you must secure the range to the oor.

This anti-tip bracket and screws can be used with wood

or metal studs.

3. Determine and mark center line of the cutout space. The

mounting bracket can be installed on either the left-hand

or right-hand side of the cutout. Position mounting bracket

against the wall in the cutout so that the V-notch of the

bracket is 12½" (31.8 cm) from center line as shown.

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation

instructions.

Slide range back so rear range foot is engaged in the

slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed

and engaged.

Failure to follow these instructions can result in death

or serious burns to children and adults.

Centerline

A. 12½" (31.8 cm)

B. Bracket V-notch

Adjust Leveling Legs

1. If range height adjustment is necessary, use a wrench

or pliers to loosen the 4 leveling legs.

This may be done with the range on its back or with the

range supported on 2 legs after the range has been placed

back to a standing position.

NOTE: To place range back up into a standing position, put

a sheet of cardboard or hardboard in front of range. Using

2 or more people, stand range back up onto the cardboard

or hardboard.

2. Measure the distance from the top of the counter

to the oor.

3. Measure the distance from the top of the cooktop to

the bottom of the leveling legs. This distance should be

the same. If it is not, adjust the leveling legs to the correct

height. The leveling legs can be loosened to add up to

a maximum of 1" (2.5 cm). A minimum of ³⁄16" (5 mm)

is needed to engage the anti-tip bracket.

NOTE: If height adjustment is made when range is

standing, tilt the range back to adjust the front legs,

and then tilt forward to adjust the rear legs.

4. When the range is at the correct height, check that there is

adequate clearance under the range for the anti-tip bracket.

Before sliding range into its nal location, check that the

anti-tip bracket will slide under the range and onto the rear

leveling leg prior to anti-tip bracket installation.

NOTE: If a Trim Kit will be used, the top of the cooktop

should be higher than the counter. See the Installation

Instructions included with the Trim Kit for the correct height.