Jenn-Air W10768190

User Manual - Page 15

For W10768190.

PDF File Manual, 48 pages, Download pdf file

Loading ...
Loading ...
Loading ...
15
6. Visually check that there is an air gap between the Blower
Motor Cover and the bottom of the range to ensure proper
blower motor ventilation.
7. Rotate blower motor cover so the bellows are in their nal
position. Ensure the rear of the bellow ange is engaged
in the retaining bracket.
8 Secure the front of the blower bellow ange to the range
frame with the supplied #8–18 x
3
8" screw.
Rotate cover
Final position
Screw
Retaining
bracket
Connect Blower Electrical Parts
1. Locate the capacitor (in Blower Motor Kit).
NOTE: The capacitor is supplied with a small harness that
terminates in a two-pin connector as shown.
Post 1 Post 2
2. Locate the capacitor storage tray in front of the blower
bellow connection point in the lower right side of the range.
3. Place capacitor in tray.
4. Secure the capacitor with the capacitor retention bracket;
then install the bracket screw.
5. Secure the blower motor strain relief, near the quick
connection end, to the blower electrical terminal cover
with the two provided screws.
Capacitor
storage tray
Retention
bracket
7. Locate the 4-pin connector on the blower motor wire
and plug it into the terminal connection point directly behind
the capacitor storage tray.
NOTE: The terminal release (clip point) will be facing
toward the front of the range.
6. Locate the two-pin connector on the blower motor wire
harness and connect it to the two-pin capacitor connector.
Loading ...
Loading ...
Loading ...