Loading ...
Loading ...
Loading ...
76
system detects another alarm signal, it can generate a new alarm since the anti-dither time has
expired.
Detection Area: Clicking this button opens a pop up screen that can be used to set detection areas.
o When the setup button is clicked, a live stream of the video is shown. The user can then set up to 4
regions, each with their own region name, sensitivity (1-100), and threshold (1-100). Each region has
a specific color, and the region selector tool is displayed when the mouse is moved to the top of the
screen.
Sensitivity is the amount of change required to increase the motion detected by a
percentage. The lower the sensitivity, the more movement is required to trigger an alarm.
Threshold is the level that the motion detection needs to reach in order to trigger an alarm.
The lower the threshold, the more likely that motion will trigger an alarm.
o To designate a zone, click and drag the mouse over the area desired. When a colored box is displayed
over the live feed, that area is now enabled for motion detection.
o After the motion detection zone is set, click the enter button to exit the motion detection screen.
Remember to click the save button on the motion detection settings screen, otherwise the motion
detection zones will not go into effect. Clicking the cancel button to leave the motion detection zone
and will not save the zone setup.
Record: This checkbox allows the user to enable the camera to record video when a motion detection alarm is
triggered.
Record Delay: This field specifies in seconds how long the delay between alarm activation and recording
should be.
Relay Out: This checkbox allows the user to enable the camera to trigger a connected alarm (connected to the
alarm port on the back of the camera) when a motion detection alarm is triggered.
Alarm Delay: This field specifies in seconds how long the delay between alarm activation and Relay alarm
activation should be.
Send Email: This checkbox allows the user to enable the camera to send an email when a motion detection
alarm is triggered.
PTZ: This checkbox allows the user to enable the camera to activate a PTZ tour when a motion detection alarm
is triggered.
Snapshot: This checkbox allows the user to enable the camera to take a snapshot when a motion detection
alarm is triggered.
To reset to default settings, click the Reset Defaults button. To refresh the page, click the Refresh button. To save
the settings, click the Save button.
Loading ...
Loading ...
Loading ...