Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 95
Opening And Closing The Power Top
Express Open/Close
Push the open switch and release it within
one-half second and the power top will open
automatically from any position. The power top
will open fully and stop automatically.
Push the close switch and release it within
one-half second and the sunroof will close
automatically from any position. The power top
will close fully and stop automatically.
During Express Open or Express Close
operation, any other movement of the power
top switch will stop the sunroof.
Manual Open/Close
To open the power top manually, push and hold
the open switch to the full open position, then
release.
To close the power top manually, push and hold
the close switch to the fully closed position,
then release.
Any release of the switch during open or close
operation will stop the power top movement.
The top will remain in a partially opened position
until the switch is operated and held again.
Pinch Protect Feature
This feature will detect an obstruction in the
opening of the power top during Express Close
operation. If an obstruction in the path of the
power top is detected, the power top will
automatically retract. Remove the obstruction if
this occurs. Next, push the close switch and
release to Express Close.
NOTE:
The Power Sliding Top may reverse motion if
closing during a severe headwind. If this
occurs, push and hold the Power Sliding Top
switch again to close the top completely.
If three consecutive power top close
attempts result in Pinch Protect reversals,
Pinch Protect will disable and the power top
must be closed in Manual Mode.
Power Top Maintenance
Use only a non-abrasive cleaner and a soft cloth
to clean the quarter window glass panel. For
important information on cleaning and caring
for your vehicle Ú page 422.
Ignition Off Operation
The power top switch can remain active in
Accessory Delay for up to approximately
10 minutes after the vehicle’s ignition is placed
to the OFF position. Opening either front door
will cancel this feature.
NOTE:
Ignition Off time is programmable through the
Uconnect system Ú page 211.
Relearn Procedure
For vehicles equipped with a power top, there is
a relearn procedure that allows you to calibrate
the power top when the “Express Mode” stops
working. To reset the power top, follow these
steps:
1. Place the ignition in the RUN position, and
start the vehicle.
NOTE:
The engine must be running to perform the
relearn procedure.
WARNING!
There is no anti-pinch protection when the
power top is almost closed. To avoid personal
injury be sure to clear your arms, hands, fin-
gers and all objects from the top’s path
before closing.
2
21_JL_OM_EN_USC_t.book Page 95
Loading ...
Loading ...
Loading ...