Loading ...
Loading ...
Loading ...
38 GETTING TO KNOW YOUR VEHICLE
Using The Retention Straps
1. There are two retention straps located on
the back of the rear seat and two
corresponding wire loops located on the
back of each B-pillar. Open the
hook-and-loop fastener on the strap and
thread through the wire loop. Fold the
hook-and-loop fastener over to keep the
seat in the folded position. This should be
done on both sides.
Rear Seat Tumble Position Retention Strap
2. To return the seat to its normal upright
position, reverse these steps.
Removing The Rear Seat
1. Push down on the release bar on each
side, and pull the seat out and away from
the lower bracket.
Release Bar Location
2. Remove the seat from the vehicle.
3. To reinstall the rear seat, just reverse these
steps.
NOTE:
Do not drive the vehicle without reattaching the
rear seat latches.
HEATED SEATS — IF EQUIPPED
The heated seat control buttons are located on
the center instrument panel below the
touchscreen and also in the Climate Control
touchscreen menu.
WARNING!
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a
collision, people riding in these areas are
more likely to be seriously injured or killed.
Do not allow people to ride in any area of
your vehicle that is not equipped with seats
and seat belts.
Be sure everyone in your vehicle is in a seat
and using a seat belt properly.
In a collision, you or others in your vehicle
could be injured if seats are not properly
latched to their floor attachments. Always
be sure that the seats are fully latched.
21_JL_OM_EN_USC_t.book Page 38
Loading ...
Loading ...
Loading ...