Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 165
Hood is open.
Transfer case is in 4WD Low or N (Neutral).
Brake pedal is not pressed with sufficient
pressure.
Accelerator pedal input.
Vehicle speed threshold not achieved from
previous auto-stop.
Steering angle beyond threshold (ESS
Models Only).
ACC is on and speed is set.
Vehicle is at high altitude.
System fault present.
It may be possible for the vehicle to be driven
several times without the Stop/Start system
going into a STOP/START READY state under
more extreme conditions of the items listed
above.
TO START THE ENGINE WHILE IN
A
UTOSTOP MODE
While in a forward gear, the engine will start
when the brake pedal is released or the throttle
pedal is pressed. The transmission will
automatically re-engage upon engine restart.
Conditions That Will Cause The Engine To Start
Automatically While In Autostop Mode:
The transmission selector is moved out of
DRIVE.
To maintain cabin temperature comfort.
Actual cabin temperature is significantly
different than temperature set on Auto HVAC.
HVAC is set to full defrost mode.
HVAC system temperature or fan speed is
manually adjusted higher.
Battery voltage drops too low.
Stop/Start OFF switch is pushed.
A Stop/Start system error occurs.
STOP/START AUTO STOP ACTIVE time
exceeds 5 minutes.
Transfer case is in 4WD Low or N (Neutral).
Steering wheel is turned beyond threshold
(ESS Models Only).
TO MANUALLY TURN OFF THE STOP/
S
TART SYSTEM
Stop/Start OFF Switch
Push the Stop/Start OFF switch (located on the
switch bank). The light on the switch will
illuminate. The “Stop/Start OFF” message will
appear in instrument cluster display within the
Stop/Start section, and the autostop function
will be disabled Ú page 111.
NOTE:
The Stop/Start system will reset itself back to
an ON condition every time the ignition is turned
off and back on.
4
21_JL_OM_EN_USC_t.book Page 165
Loading ...
Loading ...
Loading ...