User Manual - Page 163

For 2021 WRANGLER.

Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 161
ELECTRONIC SWAY BAR DISCONNECT
I
F EQUIPPED
Your vehicle may be equipped with an
electronic disconnecting stabilizer/sway bar.
This system allows greater front suspension
travel in off-road situations.
This system is controlled by the SWAY BAR
switch located on the instrument panel (to the
right of the steering column).
SWAY BAR Switch
Push the SWAY BAR switch to activate the
system. Push the switch again to deactivate the
system. The “Sway Bar Indicator Light(located
in the instrument cluster) will illuminate when
the bar is disconnected. The “Sway Bar
Indicator Light” will flash during activation
transition, or when activation conditions are not
met. The stabilizer/sway bar should remain in
on-road mode during normal driving conditions.
To disconnect the stabilizer/sway bar, shift to
either 4WD High or 4WD Low and push the
SWAY BAR switch to obtain the off-road position
Ú page 154. The “Sway Bar Indicator Light” will
flash until the stabilizer/sway bar has been fully
disconnected.
NOTE:
The stabilizer/sway bar may be torque locked
due to left and right suspension height differ-
ences. This condition is due to driving surface
differences or vehicle loading. In order for the
stabilizer/sway bar to disconnect/reconnect,
the right and left halves of the bar must be
aligned. This alignment may require that the
vehicle be driven onto level ground or rocked
from side to side.
To return to on-road mode, push the SWAY BAR
switch again.
WARNING!
Ensure the stabilizer/sway bar is reconnected
before driving on hard surfaced roads or at
speeds above 18 mph (29 km/h); a discon-
nected stabilizer/sway bar may contribute to
the loss of vehicle control, which could result
in serious injury. Under certain circum-
stances, the front stabilizer/sway bar
enhances vehicle stability and assists with
vehicle control. The system monitors vehicle
speed and will attempt to reconnect the stabi-
lizer/sway bar at speeds over 18 mph
(29 km/h). This is indicated by a flashing or
solid “Sway Bar Indicator Light.” Once vehicle
speed is reduced below 14 mph (22 km/h),
the system will once again attempt to return
to off-road mode.
WARNING!
If the stabilizer/sway bar will not return to
on-road mode, the “Sway Bar Indicator Light”
will flash in the instrument cluster and vehicle
stability may be reduced. Do not attempt to
drive the vehicle over 18 mph (29 km/h).
Driving faster than 18 mph (29 km/h) with a
disconnected stabilizer/sway bar may contrib-
ute to the loss of vehicle control, which could
result in serious injury.
4
21_JL_OM_EN_USC_t.book Page 161
Loading ...
Loading ...
Loading ...