Loading ...
Loading ...
Loading ...
40
www.insigniaproducts.com
To prepare your washer for storage:
1 Select the Quick Wash cycle and add bleach to your washer. Run your washer
through the cycle without a load.
2 Turn the water faucets off and disconnect the inlet hoses.
3 Unplug your washer from the electrical outlet and leave your washer’s lid
open to let air circulate inside the tub.
Troubleshooting
CAUTION:
If your washer has been stored in below-freezing temperatures, allow time for any
leftover water in your washer to thaw out before use.
CAUTION:
Don’t try to repair your washer yourself. Doing so invalidates the warranty.
PROBLEM SOLUTION
Washer doesn’t
start
• Make sure that your washer is plugged in.
• Make sure that the lid is closed.
• Make sure that the water source faucets are open.
• Make sure that you press the /Start/Pause button to start
your washer.
• Before your washer starts to fill, it makes a series of clicking
noises to make sure that the lid is locked and to do a quick
drain.
• Make sure that the child lock function isn’t turned on. See
Setting the child lock
on page 36.
• Make sure that the Delay option isn’t turned on. See Step 6:
(Optional) Set a delayed start time on page 34.
• Check the fuse or reset the circuit breaker.
No water or not
enough water
OR
Detergent or
softener is still in
its compartment
after the wash
cycle is
completed
• Make sure that both faucets are fully turned on.
• Make sure that the water pressure is in the range listed in Water
requirements on page 20.
• Make sure that the water inlet hoses aren’t kinked. Straighten if
necessary.
• Disconnect the hoses and clean the hose filter screens. The
screens may be clogged.
Loading ...
Loading ...
Loading ...